Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterClopay Torsion Spring Replacement: The Weatherford Owner’s Guide
If you’re searching for a Clopay torsion spring replacement in Weatherford, here’s the short version: we stock Clopay-compatible torsion springs on our trucks, quote a flat installed price before any work begins, and in most cases can have your door running again the same day. The typical installed price for a torsion spring replacement in Weatherford runs $180 to $340, depending on spring size and cycle rating. Most Weatherford homeowners discover the failure the same way: a loud bang from the garage that sounds like a firecracker, followed by a door that won’t lift more than a few inches.
The spring that just broke is the torsion spring. It’s the heavy coiled component mounted on a metal shaft directly above the closed door, and it stores the tension that makes a 150-pound Clopay door feel like it weighs about 10 pounds when you lift it. When it snaps, all that stored energy releases at once. If your Clopay door is currently stuck, keep the opener disconnected and don’t force the door up. The door is dead weight now, and that weight is the second thing that can hurt you after the spring itself.
Which Clopay Models This Applies To
This page covers torsion spring replacement for virtually every Clopay residential door line sold in Weatherford: the Gallery, Classic, Coachman, Reserve, and Canyon Ridge series, along with older Clopay Intelli-Core and Value Series doors still in service across Parker County. The distinction that matters isn’t the model name. It’s the spring itself.
Clopay doors use springs sized by wire gauge, inside diameter, length, and wind direction, all matched to the door’s weight and height. A 16×7 Clopay Coachman with a steel back and insulation runs a heavier spring than a non-insulated 9×7 Classic panel door, even though both say “Clopay” on the track sticker. The right spring isn’t a brand match, it’s a weight and cycle match. That’s the compatibility gotcha most owners never hear: two Clopay doors built in the same year can need completely different springs, and installing a spring rated for the wrong door weight is how you get a door that balances badly or eats cables.
On the OEM-versus-aftermarket question, our position is simple. Clopay-branded springs are fine. So are quality aftermarket springs from manufacturers who publish their cycle ratings and wire specs. What matters is that the spring’s cycle rating matches how you use the door. A standard 10,000-cycle spring on a door that opens four times a day lasts around seven years in Weatherford, where summer heat in the low 100s accelerates metal fatigue in uninsulated garages. A 20,000-cycle spring lasts roughly twice as long. We’ll show you the spring we’re installing and its rating before we touch a wrench. Clause 4 of The Haven Standard means you see the failed part and the replacement part, not a line item on an invoice you’re supposed to trust.
Signs Your Clopay Torsion Spring Replacement Is Failing
- The garage door won’t open more than a few inches, and the opener strains. The torsion spring isn’t broken yet, but it’s lost tension through fatigue. The opener is now lifting the full weight of the door, which will burn out its logic board if ignored. We’ve seen this on Clopay doors off Bethel Road and in subdivisions along Tin Top Road.
- You find a visible gap in the coil. Torsion springs fail by snapping, but before that they often separate slightly at one point along the coil. A one-eighth-inch gap today is warning enough. The spring is telling you it’s done.
- The door feels heavy when you pull the manual release. Disconnect the opener and lift the door by hand. A healthy torsion spring lets you lift the door with one hand and it should hold position at about waist height. If it wants to drop, the spring has lost its set.
- Cables are frayed or loose on one side. A failing torsion spring stops distributing tension evenly. The door shifts, the cables go slack on one drum, and the cable frays against the track. This is a secondary failure, and it means the spring was the original problem.
- The door is visibly crooked when opening. One spring winding tighter than the other (on two-spring systems) means the door lifts unevenly. We see this often on Clopay doors nearing the end of their spring life, especially in Weatherford homes where garage doors face west and take the full afternoon heat load.
BeforeAfterReplacement Cost & What’s Included
In Weatherford, a Clopay torsion spring replacement runs $180 to $340 installed. The range depends on three things: spring size (wire gauge and inside diameter), whether your door has one spring or two, and whether you opt for a standard-cycle or high-cycle spring. Both springs on a two-spring door are replaced at the same time, matched as a pair. Replacing one and not the other means the older spring carries the load until it fails, usually within months.
That price is parts and labor, quoted flat before work starts. Clause 1 of The Haven Standard means the written scope and the written price are in your hand before the first bolt comes off. You’ll also get a documented photo record of the failed spring and the new spring installed, included on every job, not on request. The work is backed by the 365-Day Done Right Promise: if it’s not right, we make it right.
DIY or Call Us?
Here’s the honest split. What you can safely check on your Clopay door: the spring’s wire gauge stamped on the cone, the visible coil condition, and whether the door binds when lifted manually. That’s it. What you should not do is attempt a torsion spring replacement yourself. The springs store enough energy under tension to break bone or worse if a winding bar slips. The spring is under full tension at rest. If that tension releases while you’re in the path, the result is not forgiving.
Weatherford homeowners sometimes ask us to finish a job they started after watching a video. We understand the instinct, and we’ll come out and make the door safe correctly. Call (940) 353-1271 and we’ll walk you through what we found and quote the range. Name the part, quote the range, then do the work.
FAQs
A standard 10,000-cycle torsion spring on a Clopay door in Weatherford typically lasts 6 to 8 years, though a west-facing garage with no insulation can shorten that toward the 6-year mark because heat accelerates the metal’s fatigue cycle. A high-cycle spring rated for 20,000 cycles generally lasts 12 to 15 years in the same conditions. Call (940) 353-1271 and we’ll tell you what your current spring’s cycle rating was and what the replacement would be rated for.
No. Torsion springs are not repairable. They are replaced. Once the steel has snapped or the coil has gapped, no amount of re-tensioning or re-winding will restore the spring’s original cycle life, and any attempt to repair it creates a spring that is unpredictable under load. The replacement is the repair.
Most single-spring Clopay replacements take 45 minutes to an hour. Two-spring systems with a safety inspection and balance check run about 90 minutes. We arrive with the springs, cones, and winding bars on the truck, and the whole job is documented with photos before we leave.
Yes. We carry a full range of torsion spring sizes that fit Clopay doors, along with compatible parts for LiftMaster, Chamberlain, and Genie openers. The spring gets matched to your door’s weight and height on-site, with the cycle rating confirmed before installation.
Call Servo Garage Doors Weatherford for a Written Quote
If your Clopay door has a broken torsion spring or is showing any of the warning signs above, call us at (940) 353-1271. We’ll answer live, schedule a time that works, and get your door running again with a flat, written price before any work begins. Marcus Deller and our Weatherford crew have been doing it this way since the beginning, and the photo record you’ll receive when we leave shows exactly what we found and what we fixed.
Written by Marcus Deller, Owner, Servo Garage Doors Weatherford at Servo Garage Doors Weatherford, serving Weatherford and nearby areas.